- Posts: 13
- Thank you received: 2
Question
Estlcam Backlash 420
- Whakahere
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
08 Jul 2016 11:50 #35635
by Whakahere
Estlcam Backlash 420 was created by Whakahere
I have been using Estlcam with my 420 and I have noticed the circles are not round. How do I deal with this?
Please Log in or Create an account to join the conversation.
- DocBrown
-
- Offline
- Forum Nutzer
-
08 Jul 2016 13:15 #35639
by DocBrown
Viele Grüße
Hartmut
V2/420 China 800W wassergekühlt
UCCNC & ARDUINO ESTLCAM Controller
ESTLCAM & QCAD
DK5LH/G11
Replied by DocBrown on topic Estlcam Backlash 420
It happens often like hear in this new post in German:
Circle
Check all grub screws, loose spindle nuts, belt pulleys and everything where you think it's tighten but is not...
Check all grub screws, loose spindle nuts, belt pulleys and everything where you think it's tighten but is not...
Viele Grüße
Hartmut
V2/420 China 800W wassergekühlt
UCCNC & ARDUINO ESTLCAM Controller
ESTLCAM & QCAD
DK5LH/G11
Please Log in or Create an account to join the conversation.
- Whakahere
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
- Posts: 13
- Thank you received: 2
08 Jul 2016 20:57 #35649
by Whakahere
Replied by Whakahere on topic Estlcam Backlash 420
I think you could be right. I have gone through and tightened everything as there were a few things loose. see if that helps.
Please Log in or Create an account to join the conversation.