- Posts: 152
- Thank you received: 97
Question
Very cheap clamps I did today
- jvalencia
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
20 Aug 2015 14:18 #24441
by jvalencia
Stepcraft 2 840
Kress 800 FME
UCCNC + UC100
V-Carve + QCad
Very cheap clamps I did today was created by jvalencia
From a 1meter x 35mm x 2mm aluminum flat bar like this that cost about 4-5 euros I got 4 x 60mm clamps (and could get a lot more):
This image is hidden for guests.
The schematic is this:
This image is hidden for guests.
And the result is:
This image is hidden for guests.
This image is hidden for guests.
This image is hidden for guests.
This image is hidden for guests.
This image is hidden for guests.
The tools I used were a hand metal saw, a drill press, a vice and a hammer.
This image is hidden for guests.
Please log in or register to see it.
The schematic is this:
This image is hidden for guests.
Please log in or register to see it.
And the result is:
This image is hidden for guests.
Please log in or register to see it.
This image is hidden for guests.
Please log in or register to see it.
This image is hidden for guests.
Please log in or register to see it.
This image is hidden for guests.
Please log in or register to see it.
This image is hidden for guests.
Please log in or register to see it.
The tools I used were a hand metal saw, a drill press, a vice and a hammer.
Stepcraft 2 840
Kress 800 FME
UCCNC + UC100
V-Carve + QCad
The following user(s) said Thank You: High-Tower, Dirk, bvps, Mr. B, speedo, hale2160, MacJ
Please Log in or Create an account to join the conversation.