Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Jokel wrote: kann ich 2 Installationen auf einem Rechner nutzen wenn ich die in verschiedene Ordner installiere?
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Jokel wrote: Ich habe die WzL mal geschlossen und wollte diese dann wieder öffnen und schon ging nix mehr.
Jokel wrote: kannst Du was einbauen das die Fenster die bei den Aktionen aufgehen auf dem 2. Monitor verankert bleiben?
Alpenkreuzer wrote: - Einträge waren futsch, nur noch Christians vorhanden
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Ich denke dies könnte eine sehr hilfreiche Parametersammlung für alle Nutzer werden - allerdings fürchte ich auch das es noch viel Arbeit für Christian bedeutet um eine brauchbare Auswertung der gewachsenen Datenbank zu präsentieren. Mit "nur" sammeln ist es leider nicht getan ...Christian Knüll wrote: Diese Datenbank soll für alle frei verfügbar Werkzeugparameter zu verschiedenen Materialien und Maschinen sammeln, denn welche
Vorschübe, Drehzahlen und Zustellungen man bei welchem Material verwenden sollte ist nicht nur für Anfänger oft eine sehr schwierige Frage.
Ja, sehe ich genauso. Ich stelle mir gerade vor das meine Suchvorgaben 500+ passende Fräsparameter raus werfen - und diese Unterscheiden sich dann nur um geringe Abweichungen wie z.B. 5 RPM in der Spindel speed. Natürlich funktionieren alle diese Angaben - nur welche davon pick ich mir raus um sie an meinem Projekt anzuwenden?spur0 wrote: Hallo Jörg,
Ich hoffe nicht dass dies so funktionieren soll wie eben bei dir, dies wäre aus meiner Sicht wenig hilfreich. So würde jeder Schwachsinn seinen Weg in die Datenbank finden. Wenn ich etwas teste und dies speichere wären die Daten sofort online, wenn ich 0,05 mehr/weniger zustelle oder um 50 Umdrehungen den Speed ändere wieder ein neuer Eintrag, das kann doch nicht Sinnvoll sein, die Datenbank würde ja extrem wachsen mit zum Teil unsinnigen Einträgen.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
We use cookies on our website. Some of them are essential for the operation of the site, while others help us to improve this site and the user experience (tracking cookies). You can decide for yourself whether you want to allow cookies or not. Please note that if you reject them, you may not be able to use all the functionalities of the site.