- Posts: 102
- Thank you received: 67
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
drilldevil wrote: AKÜ-FI?
Please Log in or Create an account to join the conversation.
Stepomat wrote:
drilldevil wrote: AKÜ-FI?
was auch immer du meinst ......
Ganze Sätze sind verständlicher
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
RonaldMcDonald wrote: Hallo Stepomat,
ich gehe davon aus, dass du das CAM auch in Fusion machst. Wenn du hier die Kontur auswälst, welche gefräst werden soll, dann erscheint irgendwo an der Kontur ein roter Pfeil. Der gibt an, auf welcher Seite der Kontur der Fräser laufen wird. Ich habe dir mal ein Bild davon angehängt. Klickst du auf den Pfeil, so wird die Seite gewechselt.
Wenn das der richtige Tipp war, freue ich mich natürlich über ein Dankeschön.
Liebe Grüße,
Ronald
Please Log in or Create an account to join the conversation.
We use cookies on our website. Some of them are essential for the operation of the site, while others help us to improve this site and the user experience (tracking cookies). You can decide for yourself whether you want to allow cookies or not. Please note that if you reject them, you may not be able to use all the functionalities of the site.