- Posts: 13
- Thank you received: 8
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
sumstefan wrote: Hallo,
passt auf, dass ihr die Regler nicht zu schwach auslegt.
Alles was bisger gemessen wurde "Volllast" - war Leerlauf so wie ich das gelesen habe.
Oder irre ich mich ???
Wer jetzt mal ne Platte mit großem Fräser planen oder gar tiefe Taschen Fräsen möchte,
kann - muß nicht - ein "rauchendes Wunder" erleben.
Ich tendiere dazu den Regler in der Stärke auszulegen, wie vom Hersteller empfohlen wird.
Manch ein Regler geht auch schon mal in Flammen auf - Überlast .... ist nicht immer drin was draufsteht.
Wenn evtl. einer mitliest, der ne Stepcraft HF hat, der kann ja mal nachsehen was Fa. Hacker da hinein gepackt hat.
Gruß Stefan
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
udoc wrote: ...
Bei vermessen des Umkehrspieles habe ich auf der X-Achse und der Z-Achse mit jeweils 20 Klicks (= Motorschritten) auf der Messuhr 0,1 mm Weg zurückgelegt. Soweit, sogut und das stimmt ja auch. Auf der Y-Achse brauche ich aber 25 Klicks (Motorschritte) für 0,1 mm
...
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
We use cookies on our website. Some of them are essential for the operation of the site, while others help us to improve this site and the user experience (tracking cookies). You can decide for yourself whether you want to allow cookies or not. Please note that if you reject them, you may not be able to use all the functionalities of the site.