could be slow response... 1.0034 runs on flash and runs slow on slow computers. open GL version is a lot faster. suggest getting a refurbished lapto...

if your using a UC100 and wire direct to the output then nothing will be isolated. better solution is to use a UC300 - connect one port to the SC j...

Does sound like something like that Peter.. Evan - try milling a straight slot with the cutter - one slingle line profile and measure the width of ...

Did you tick the "enable backlash" box?

lost steps on the z retract. tune Z axis and lubricate it well. turning down the rapid movement velocity can also help. well tuned Z axis ...

the new UCCNC has a new algorithm the backlash acceleration is the setting that needs to be configured this needs to be 20% higher than the acce...

you have to use a UC100 to use the UCCNC with the STEPCRAFT.

IF it opens in demo mode - its the drivers. incorrect license will show up as "valid licence key not found) if you are not seeing a blue light c...

you can get a ferrite ring and wrap the USB cable around this a few times - this does a good job of suppressing some noise. like this And you ...

you have noise in your system that is freezing the UC100 chip. The UC100 is not at fault - this is most likely a noise issue Check your USB con...

Select all vectors (so they all go pink) Then select "mirror selected vectors" under the "edit vectors" menu on left.

As long as Z has longest cable its fine. Cable too long does not matter cable too short does 🙂

Yup - part is correct. Slight change in shape from manual

OpenGL UCCNC OpenGL UCCNC released

How old is PC? sounds like not enough resources. disable anti virus etc also that can cause issues sometimes.