- Posts: 1
- Thank you received: 0
Question
Problem with Y-axis
- Frankie
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
25 Oct 2015 12:49 #26226
by Frankie
Problem with Y-axis was created by Frankie
Hello,
Yesterday I recieved my Stepcraft 840. I have build the whole machine, but i have some problems. I hope someone can help me.
When i want to move the machine with the laptop. The moving process from the Y-axis gets jammed. It's stuck, won't move from left to right.
(sorry for bad englisch, i'm dutch)
Please help me.
Yesterday I recieved my Stepcraft 840. I have build the whole machine, but i have some problems. I hope someone can help me.
When i want to move the machine with the laptop. The moving process from the Y-axis gets jammed. It's stuck, won't move from left to right.
(sorry for bad englisch, i'm dutch)
Please help me.
Please Log in or Create an account to join the conversation.
- tikka
-
- Offline
- Forum Nutzer
-
Less
More
- Posts: 105
- Thank you received: 27
26 Oct 2015 18:04 - 26 Oct 2015 18:05 #26262
by tikka
Stepcraft 600SF (version 1) parallel port
Proxxon IBS/E
Mach3
devCad Cam Pro; devWing Cam; devFus Cam; Profili Pro 2
Replied by tikka on topic Problem with Y-axis
Did you check the following topic:
here
. Does it make any particular sound when it gets stuck?
Stepcraft 600SF (version 1) parallel port
Proxxon IBS/E
Mach3
devCad Cam Pro; devWing Cam; devFus Cam; Profili Pro 2
Last edit: 26 Oct 2015 18:05 by tikka.
Please Log in or Create an account to join the conversation.
- Denus
-
- Offline
- Forum Nutzer
-
- Jack of all hobbies, master of none!
28 Oct 2015 14:14 #26349
by Denus
Eurotools-24 G-500 & custom-made aluminium table
Kress 800
TB6560 4V3, UC100, UCCNC
Replied by Denus on topic Problem with Y-axis
I had there same issue with my 420/2 at start, but loosing and tighten the bolds of the frame again while moving the unit was the solution for me. The frame was not 100% levelled, and that caused resistance.
I have now many hours of milling, and the problem never came back.
I have now many hours of milling, and the problem never came back.
Eurotools-24 G-500 & custom-made aluminium table
Kress 800
TB6560 4V3, UC100, UCCNC
Please Log in or Create an account to join the conversation.
- Chillimonster
-
- Offline
- Forum Nutzer
-
Less
More
- Posts: 13
- Thank you received: 7
18 Nov 2015 15:44 #27174
by Chillimonster
Replied by Chillimonster on topic Problem with Y-axis
I am going to have to do that with my 840/2
On a number of occiaions the X / Y had stalled, but only at the far end of travel (IE whrn doing full sized pieces)
Only today i have wasted a dozen pieces of wood (18mm MDF so not too expensive)
On a number of occiaions the X / Y had stalled, but only at the far end of travel (IE whrn doing full sized pieces)
Only today i have wasted a dozen pieces of wood (18mm MDF so not too expensive)
Please Log in or Create an account to join the conversation.