Rory that could be my issue with Y axis, I'm sure its something to do with lubrication Ive noticed that when the problem occurs if i put a fan heater ...

Ive noticed if numlock on the keyboad is turned on then the motors dont stop. Try turning off numlock on the keypad.

Same issue with Y axis only. Im now having to adjust it the last two occasions in the past few days ive used it. I retune it works fine do some cutti...

Im going to be using a naze32 FC. AUW as in the image is 173g. I can cut more material out to get the weight down even more.

What is the base material you've used? Thanks.

Started cutting out in G10material now, everything is 90% done. Will post a vid of some sort of chatter/noisse when cutting the 3.2mm arms, although t...

Thanks, ill try that.

Uccnc will only except one toolpath at any one time right? so after i load the toolpath for the 2mm cut, does it matter where the x/y postion is?

Triton DCA300 Dust Collection Bucket. It has two suction inlets so you can use two hoses. filter clogs up pretty quick with fine dust though, so its...