Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Assembly and Maintenance
2
Beiträge
2
Benutzer
0
Likes
3,799
Ansichten
Themenstarter
Hello,
After having assembled my V2 600 I am now in the phase of getting to know the machine.
During trial runs yesterday the machine had a tendency to loose steps on the Y-axis while traveling at low speed around half way down the table. It is running smooth towards the ends.
During assembly it moved smoothly all the way when moved by hand.
Is anyone familiar with this problem? Does it have to do with the cable movement under the table?
Best regards,
Andries.
Veröffentlicht : 05/08/2015 12:00 pm
On my V2 840 I put 2 long pieces of electrical tape over the top and bottom edges of the base plate slot. This stopped the conduit from catching when moving on the Y axis.
Veröffentlicht : 05/08/2015 2:23 pm
