- Posts: 2
- Thank you received: 0
Question
Go to XYZ position after job
- lesilobe
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
27 Feb 2023 10:30 #62987
by lesilobe
Go to XYZ position after job was created by lesilobe
Hi there,
I was wondering if ther is a way to tell my stepcraft to go to a specific position after a job.
I mean when she finish the milling job, she just go to 0 on Z and turn off.
Is it possible to tell her to go back at Home All position or to an XYZ coordinate ?
Thanks
I was wondering if ther is a way to tell my stepcraft to go to a specific position after a job.
I mean when she finish the milling job, she just go to 0 on Z and turn off.
Is it possible to tell her to go back at Home All position or to an XYZ coordinate ?
Thanks
Please Log in or Create an account to join the conversation.
- CNCMiller
-
- Offline
- Forum Nutzer
-
Less
More
- Posts: 224
- Thank you received: 81
01 Mar 2023 18:42 #62995
by CNCMiller
SC 1/420 + Gantry extension, Kress 1050 FME-P, NeJe 20W Laser, WinPC-NC USB v4.00, Vectric Aspire 9, SolidWorks 2021
Replied by CNCMiller on topic Go to XYZ position after job
Yes you can.
How that depends on which control software you use.
How that depends on which control software you use.
SC 1/420 + Gantry extension, Kress 1050 FME-P, NeJe 20W Laser, WinPC-NC USB v4.00, Vectric Aspire 9, SolidWorks 2021
Please Log in or Create an account to join the conversation.