Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Operation
2
Beiträge
2
Benutzer
0
Likes
4,183
Ansichten
Themenstarter
Can my Stepcraft2 840 be run in Inch mode (G20) rather than Metric mode (G21)?
Veröffentlicht : 25/06/2017 7:44 pm
Check the UCCNC user manual Section 4.1 to see if the G20 code is supported.
http://www.cncdrive.com/UCCNC/UCCNC_usersmanual.pdf
It jumps from G19 to G28 so it doesn't look like it. I noticed UCCNC telling me that G21 was unsupported recently so it might return an error message in any case.
Doug
Stepcraft 2/840, StoneyCNC industrial HF spindle, 4th axis, TurboCAD 2016 Professional 64 bit, MeshCAM, GWizard feeds & speeds calculator, UCCNC
Hobby use: guitar building (luthiery), https://dsgb.net
Veröffentlicht : 27/06/2017 7:55 am
