Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Operation
2
Beiträge
2
Benutzer
0
Likes
2,198
Ansichten
Themenstarter
Hello,
Sorry to bother everyone but my machine is refusing to move the Z axis. The motor is whirring and if I take it apart it spins fine, but as soon as I put everything together it jams.
When I use the SC program to manually look at it, it spins fine but only in one direction, whether I press + or -.
Ditto, when i adjust the jog feed to 10 it just refuses to move at all.
Any help appreciated.
SC 300/2
Veröffentlicht : 16/09/2020 2:35 pm
I think you have a bad motor.
check the connection on the main board no wire damage all correct connected?
You can try to change temporary the motor to check if it is no software issue.
last contact stepcraft or your vendor
good luck
SC 1/420 + Gantry extension, Kress 1050 FME-P, NeJe 20W Laser, WinPC-NC USB v4.00, Vectric Aspire 9, SolidWorks 2021
Veröffentlicht : 16/09/2020 3:02 pm
