Dear user, the forum software has been updated. For the first login please reset your password.
Winpc nc economy
Hi to all the forum, maybe someone have the file with the parameters from the machine stepcraft 600 to load it in the winpc nc , thanks.
Hi jeyb,
here you are! These are the 2 sc600 files I could find in the starter version of WinPC NC.
SC 420 mit DIY parallel + Proxxon mit Mod + HF500 + SprintLayout + LibreCAD/QCAD + FreeCAD +WinPC starter/USB->EstlCAM + EstlCAM LPTAdapter + EstlCAM Handrad + DIY Vakuumtisch
Gruß, Andreas
Thanks MagIO2 for the quick reply!!
ok the parameters works its all corect, but i need and the parameters from singnals because i have the lpt1 version of stepcraft 600 and i dont understand how to fill the parameters in the winpc nc.the parameters is hear https://www.stepcraft-systems.com/images/Service/connection-diagramm-v1.pdf
Hi Jerb
this is the Default Setting in WinPCNC Economic
5.1.1. Pin assignment of clock/direction version:
Pinning LPT 1
(clock/direction)
All signals on the LPT printer ports present 5V TTL level.
Pinning of the first LPT port is as follows:
Pin 2 output direction motor X
Pin 3 output clock motor X
Pin 4 output direction motor Y
Pin 5 output clock motor Y
Pin 6 output direction motor Z
Pin 7 output clock motor Z
Pin 8 output direction motor 4 (i.g.tangential axis)
Pin 9 output clock motor 4 (i.g. tangential axis)
Pin 1 output drilling spindle on/off (default)
Pin 14 output coolant pump on/off (default)
Pin 16 output current reduction (default)
Pin 17 output job works (default)
Pin 10 input reference switch X (default)
Pin 11 input reference switch Y (default)
Pin 12 input reference switch Z (default)
Pin 13 input sensor/surface block (default)
Pin 15 input vacant
Pin 18-25 signal mass (0V GND)
You have to Change following Settings:
Pin10 Input from Reference Switch x to tool length sensor
Pin11 input reference switch Y to emergency stop
Pin12 input reference switch Z (Default) to Input reference Switch x, y and z
This should be all you need to change.
Please have a look at WinPCNC Handbook, Page 83.
Kind regards Christian
Weil die Klugen immer nachgeben, regieren die Dummen die Welt.
Thanks vhoren
please to tell me someone how to create a 3d file to winpcnc-economy and create a reilef picture.PLEASE HELP I NEED THIS INFORMATION IF SOMEONE KNOW TO TELL ME QUICKLY 🙁
- 44 Foren
- 7,338 Themen
- 63.2 K Beiträge
- 3 Online
- 26.3 K Mitglieder