Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Tracing an object in Vcarve
Software
2
Beiträge
2
Benutzer
0
Likes
3,655
Ansichten
Themenstarter
Evening Gents,
So ive been asked to make a Buzz Lightyear figure to go on a kids bedroom wall.
Ive found a vector image that id like to use, but when I trace it into Vcarve, it traces the inside and the outside of the outline if that makes sense.
That makes the image far too complicated and it wont cut even using a 2mm end mill, too much detail. Is there any way to trace it with 1 line only?
Heres a screenshot of the image id like to trace, and the outcome when I use the trace bitmap tool...
Hope ive described well enough
Veröffentlicht : 11/08/2017 9:46 pm
Hi,
ok ... this one needs still work but maybe more usable?
It's not only about tools it's also about skills! 😉
Veröffentlicht : 11/08/2017 11:16 pm
Forum Information
- 44 Foren
- 7,339 Themen
- 63.2 K Beiträge
- 12 Online
- 26.3 K Mitglieder
Unser neuestes Mitglied: Thommyvanho
Letzter Beitrag: D420 V2 mit der Vakuumplatte von Stepcraft betreiben
Forum Icons:
Das Forum enthält keine ungelesenen Beiträge
Das Forum enthält ungelesene Beiträge
Themen-Icons:
Unbeantwortet
Beantwortet
Aktiv
Heiß
Oben angepinnt
Nicht genehmigt
Gelöst
Privat
Geschlossen