Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Operation
4
Beiträge
2
Benutzer
0
Likes
4,847
Ansichten
Themenstarter
Can anybody help?
My SC600 has ceased moving in the x and y direction. I am using WINNCPC with USB and only the Z axis and the 4th axis are responding. When I tell it to go to reference it drives the z axis to the limit switch but then fails to move the x and y axis. I have tried it with two different laptops with the same result. Sometimes I get a "Reference Switch Active" warning when it fails, other times it just sits there. When I do a status check from the WINPCNC menu I see a red light on the 4th/C axis, but am not sure what this is telling me.
This just started happening yesterday after using the 4th axis stepping motor for the first time for rotating a piece and I am stuck. I am thinking maybe I have a stuck switch but I am not sure how to proceed.
SC 600. WinPCNC Pro/UNC, 3D Printhead, Aluminum Bed, Foam Cutter, Engraver
Veröffentlicht : 08/07/2015 5:00 pm
Check the wiring. Loose contacts are a very common problem.
Daniel
-----
Veröffentlicht : 08/07/2015 6:07 pm
Themenstarter
I checked the wiring and all connections are tight.
I then swapped the stepping motor connections for the Y and the Z axis. After doing so, the Z axis in the program moves the Y axis and the Z axis now fails to move. I believe this tells me that the stepping motors are good since they move appropriately when driven by the z-axis driver. I also believe this tells me that the problem lies in the circuitry on the StepCraft microstep controller board. There don't seem to be any fusible links I can replace. Any thoughts? I guess I need to replace this board.
SC 600. WinPCNC Pro/UNC, 3D Printhead, Aluminum Bed, Foam Cutter, Engraver
Veröffentlicht : 08/07/2015 7:05 pm
Call stepcarft. There has been cases of failure of the driver board.
Daniel
-----
Veröffentlicht : 08/07/2015 9:41 pm
