Problem with the Z axis.

Operation

Letzter Beitrag von Luis Vor 9 Jahren

3 Beiträge

2 Benutzer

0 Likes

4,774 Ansichten

RSS

Luis

(@fernandes)

Beiträge: 2

New Member

Themenstarter

First of all,
hello to all the users and administrators of this forum.
This is my first post.

I just finished the assembly of my Stepcraft-2/600.
Everything seems to be ok except the Z axis. Some times it goes up others it goes down with the same fast button pressed on the WinPC-NC, and when I press the slow button for up or down the motor shake and makes erratic movement, does not move continuously on any direction.

Any suggestion?

Regards

Veröffentlicht : 10/07/2015 8:12 pm

Helmut Brunn

(@mogul)

Beiträge: 791

Prominent Member

Hello Fernandes,
the cause is probably a problem contact or loose contact of the lines of the stepper motors. Control the Z lines if they have all good contact.

Cordialmente,
Helmut

Veröffentlicht : 10/07/2015 8:54 pm

Luis

(@fernandes)

Beiträge: 2

New Member

Themenstarter

Hello Mogul,
Thanks for your advice.
After checking and rewiring all the conections, the problem was solved. I already made the first engraving test from the Getting Started Manual and worked fine.

Thanks a million Mogul,
you saved my day.

:cheer:

Veröffentlicht : 10/07/2015 10:22 pm