Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Accessories
3
Beiträge
3
Benutzer
0
Likes
6,903
Ansichten
Themenstarter
Hi,
I'm looking to add some extras to my setup, incluing a coolant solenoid and control of FRENIC Mini inverter for the ELTE Spindle I'm using.
I'm guessing the way to do this with the SC100 is to wire things up to the D Connector? If that is the case, does anyone know the pin outs? I'm guessing they are different from the pins that can be configured within UCCNC?
Many thanks in advance
Rob
Veröffentlicht : 01/05/2016 5:16 pm
I don't know what a SC100 is but does this help you?
https://www.stepcraft-systems.com/images/Service/EN-Operating-Instructions-SC2-v2.pdf
Page 17
Veröffentlicht : 01/05/2016 8:01 pm
if your using a UC100 and wire direct to the output then nothing will be isolated.
better solution is to use a UC300 - connect one port to the SC just like the UC100 and then use the other ports to connect to your hardware via breakout board with isolation.
Veröffentlicht : 03/05/2016 5:24 pm
