Dear user, the forum software has been updated. For the first login please reset your password.
Installation steps 2.1, 2.1, 5.2 and 6.5
Dears
I'm installing my Stepcraftv2 840 CNC and I have a huge difficulty aligning parts as shown in the attached images from the installation manual (Installation steps 2.1,5.2 and 6.5 asks you to leave 1mm from 2 dimensions and I don't know how to do that)
also what is the impact of a misalignment (the 1mm is not achieved) on the overall accuracy of the machine ?
is there any other way to overcome this issue ?
Best Regards
I had the same problem but I think the most important thing is, that everything has the same distance. I cannot see any problem if all distances are 0.5mm or so.
Viele Grüße
Hartmut
V2/420 China 800W wassergekühlt
UCCNC & ARDUINO ESTLCAM Controller
ESTLCAM & QCAD
-----------------------------------
DK5LH/G11
Yes it is difficult to leave 1mm on each end as shown in the manual. At the end i had to adjust them again and the final stage .
Stepcraft 2 430
Kress 800 FME
UCCNC + UC100
Cut2D Desktop
- 44 Foren
- 7,338 Themen
- 63.2 K Beiträge
- 1 Online
- 26.3 K Mitglieder