Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Operation
3
Beiträge
3
Benutzer
0
Likes
4,890
Ansichten
Themenstarter
small problem has arisen, when running a simple pocket program, three quarters of the way through Z gets lost and starts cutting about 10mm deeper than original intended path, i am going nowhere but using up timber .
any other people having this issue.
420 with less than 6 months use
Veröffentlicht : 10/04/2016 8:32 am
Sounds like the z axis is losing steps. check the z axis and see if there is any play. i had a similar issue and the brass lead screw nut was worn.
Veröffentlicht : 10/04/2016 7:35 pm
lost steps on the z retract.
tune Z axis and lubricate it well.
turning down the rapid movement velocity can also help.
well tuned Z axis will run at 5000mm/min rapid velocity (under testing conditions)
always bring it back down lower than 3000 after testing for actual toolpath use.
Veröffentlicht : 14/04/2016 3:09 am
