Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Assembly and Maintenance
4
Beiträge
2
Benutzer
0
Likes
1,382
Ansichten
Themenstarter
Hi
I have a D3.840, I have it set up so it can run from the PC. But whenever I start up WinPC NC, it says the machine is not ready. I open the signal monitor and the "Not ready" signal is always on.
I've done:
- E-stop is not triggered
- Limit Switches
- Limit Switches Cables
- Motors & Motor cables
- Double-checked the cables connecting to the PCB
I've also tried power cycling both PC and the CNC, but nothing has helped.
I'm about to test if the E-stop button does work or not, but I thought I'd go ahead and write my post here. If I find out what it was I'll update on this post.
Veröffentlicht : 07/04/2023 2:42 pm
Hello,
"Not Ready" warnig is mostly a not functioning communication of one of the steppermotors.
So check if the X-Y-Z cables have no wirebreak or false contact in the connector.
Measure also the E-stop switch if that one doesn't "hang" e.q. stays closed.
But most likely your problem is a wirebreak or bad connector somewhere.
SC 1/420 + Gantry extension, Kress 1050 FME-P, NeJe 20W Laser, WinPC-NC USB v4.00, Vectric Aspire 9, SolidWorks 2021
Veröffentlicht : 12/04/2023 10:41 am
Themenstarter
Hi CncMiller - I individuelly checked all XYZ stepper motor cables and they seem intact.
At the same time I did the same check on the stopswitches.
On stepcrafts request I sent the circuit board to them, they checked the boards and they found no errors.
I also performed the e-stop check as well. It is not hanged in one state.
I'm running out of ideas to try now and stepcrafts support hasn't been very helpful since I got the board back.
Veröffentlicht : 28/04/2023 5:19 pm
Hi Zhoot,
This is the explanation of the "Error" message from the original manual.
"Machine not ready
The machine has not been switched on or a fault is present. Carefully
check the machine and its interfaces and resolve the issue."
So to clear what you have done:
- Switch on machine. No error
- Start WinPC-NC. Error Machine not ready
- Check E-stop by twisting the knop.
Try this:
- Don't power up the machine.
- Start WinPC-NC. Warning will come on screen "USB hardware not found" . Accept
- check the correct machine profile is loaded.
- check all settings made in the program for your machine are correct.
- check the USB cable connection.
- Close WinPC.
Restart:
- Switch on machine.
- Start WinPC-NC.
Still error, than there is still a problem in the hardware of the machine or connection to the computer.
For further ideas I need more info about your setup Software and Hardware.
SC 1/420 + Gantry extension, Kress 1050 FME-P, NeJe 20W Laser, WinPC-NC USB v4.00, Vectric Aspire 9, SolidWorks 2021
Veröffentlicht : 07/05/2023 2:52 pm
