Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Show us your Stepcraft Creations
7
Beiträge
5
Benutzer
0
Likes
8,109
Ansichten
Themenstarter
Almost confined the engraving to the bin when i lost connection to uccnc when i turned on an air compressor that was connected to the same power extension as the stepcraft when i was engraving. Had to reboot and mangaged to get near to the original zero position.
Veröffentlicht : 24/03/2016 11:13 pm
Great work . Well done
Stepcraft 2 430
Kress 800 FME
UCCNC + UC100
Cut2D Desktop
Veröffentlicht : 13/05/2016 11:26 pm
Hello,
Would you share, how did you engrave acrylic? What bit and setting did you use?
Thank you for your time and answer.
Veröffentlicht : 04/05/2017 1:47 am
Themenstarter
I used a v cutter for engraving with a pass depth of 0.3mm, stepover 20%, spindle speed 17000rpm, feedrate 25mm/sec.
I used a 2mm single flute to cut out the profile SEE VIDEO AS I USED SAME SETTINGS HERE.
Veröffentlicht : 07/05/2017 8:53 pm
thank you for sharing.
Veröffentlicht : 09/05/2017 6:31 am
